A 40 ft High Cube With Two Double Doors on the Long Side
A standard 40 ft high cube shell, taken and cut twice on the long side. Two double doors, each in its own frame, finished flush in white. Photographed closed on the apron, before loading.
Cutting a container is the easy part
Two openings, two frames, one shell
The corrugated long side is a shear panel: it carries the racking load of the box. Cut two holes in it and the load has to go somewhere, which is why each opening gets a welded frame tied back into the top rail, the floor rail and the nearest post.
The frame also gives the door something flat to seal against. Corrugation is not a sealing face, however much gasket you put on it.
Doors set flush, not proud
Both sets sit flush with the outside face. Nothing to catch on a strap, a sheet or a person walking past, and the box still stacks and still fits a trailer the way a container does.
Four leaves, container hardware throughout. The people opening these doors have opened container doors before, and they will not read a manual.
Cut, framed, sealed

Each set is a pair of leaves with lock bars and a gasket round the perimeter. The pair is wide enough to take a pallet through, square, on a pallet truck.

A flat steel frame welded round each opening and tied into the rails. The gasket compresses on steel, not on corrugation.

Corner castings, top rail and the 45G1 plate untouched. The box is still lifted by the castings, stacked by them and secured by them.
How it went together
The shell, in four numbers
Taken from the shell and the door schedule. Commercial values are not disclosed.
On the apron



The products this build maps to
Photographs are from the delivered project. The client is not named and the site is not disclosed. Commercial values are withheld; the figures describe the build as shipped.
Two doors or four, the frame is the same problem.
Send the footprint of what has to go through the side and the height of the trailer it will sit on, and we will place the openings before anything is cut.


